Clearing phosphates in eutrophic waters
Using cerium-based nanocomposites
Jana Petrovska
Jovana Nacheva
Introduction
Phosphorus participates in many physiological and chemical reactions in every cell of the living body, and it is also essential to promote biological growth.
However, its overabundance in nature can lead to eutrophication, a global environmental challenge. This study explores the efficacy of cerium‐based nanocomposites in mitigating eutrophication in the river Black Drim, North Macedonia.
Moreover, it can be used as a supplement to biotechnology for treating low concentrations of phosphorus and can also be employed to remove high concentrations of phosphorus alone because its merits include low energy consumption, high efficiency, and recyclability.
01
Executive
Summary
Key Goals
The goal is to safeguard aquatic ecosystems by ensuring clear water through the removal of phosphates, which will protect plants and animals from extinction and reduce the toxins released by algae, thereby preventing irritations caused by algal blooms.
Strategies
• Direct Addition: Introducing cerium-based nanocomposites directly into eutrophic waters.
• Filtration Systems: Incorporating nanocomposites into water filtration systems to treat water as it passes through.
• Sediment Treatments: Applying nanocomposites to sediments where phosphate accumulation is high.
Expected Outcomes
02
Methods
Synthesizing nanocomposites . Weighing out 20.08g of ferrocerium alloy, and assuming its composition is 42% cerium, 24% lanthanum, and 22% iron by weight, we calculate the volume of nitric acid required for the complete reaction of the alloy.
1



03
Methods
2
Work in a fume hood due to toxic gas release!
Add deionized water and nitric acid to the alloy, heat until dissolved, then cool and split into two portions. Treat one portion with urea, oxalic acid, and adjust pH to 5, then to 10, isolate the precipitate, dry, and calcinate. Split the other portion, adjust pH to 4, treat one with silica gel and 𝑁𝐻4OH, filter, wash, dry, and calcinate both at 400°C for 3h.
04
Methods
3
Determining the best phosphate absorbent
Prepare a standard phosphate solution, then mix 50 mL of this solution with 0.2 g of the adsorbent materials in Erlenmeyer flasks and stir for 1 hour. Filter the solutions through syringe filters, transfer 25 mL of each sample to volumetric flasks, add reagents, and make up the volume. Record the absorbance of each sample at the wavelength of maximum absorbance and calculate the removal of phosphates by adsorption. Repeat the experiment with a real-world sample and compare the results.
4
Real-world application
Collect water sample suspected to have high phosphate, like from algae-rich areas. Make a calibration curve with standard phosphate solutions (50 to 600 μg/L). Prepare these from a 1 mg/L solution, diluting and adding reagents. Measure absorbances to plot curve. Filter the real sample through 0.45 μm filter, then analyze the results.
05
Results


06


Black Drim
07
Photo
Gallery


08
Photo
Gallery


09
Photo
Gallery


10
Thank You
For Attention

